Specifications

Audio Track Recording

How to Auto-Configure for

DiskTracks

Perform the COPY O.S. TO DISK command to your boot device (SCSI or FLOPPY). This

doesn’t have to be the same as your REC SCSI DRIVE.

Run

the CONFIGURE AUDIO TRACKS command, and configure the ASR-10 for the desired

type of Audio Track Recording/Playback.

Press (COMMAND] then (SYSTEM -MIDI), and use the (ARROW) buttons to locate the SAVE

GLOBAL PARAMETERS command. The display shows:

SYSTEM STOP

SRL’E GL3BRL

PRRRflETERS

Press (ENTER-YES] to run the SAVE GLOBAL PARAMETERS command to your boot device.

(You may have to run the CHANGE STORAGE DEVICE command if the current REC SCSI

DRIVE is not the same as your boot device.)

You can now power down after saving you work (SONG+ALL SEQS file followed by a Bank

file, remember?).

If you were configured for DiskTracks when you ran the SAVE GLOBAL PARAMETERS

command, confirm that all SCSI cables are properly connected, power on your SCSI Storage

Device, then boot the ASR-10. The CONFIGURE SCSI ATRKS? prompt will be displayed, as

described on the previous page.

Note:

Invoking the LOAD GLOBAL PARAMETERS command will not invoke the

Auto-Configure function.

Refer to the ASR-10 Musician’s Manual for more information about the SAVE GLOBAL

PARAMETERS command, and read the pertinent sections in this document for additional

information about setting up a SCSI rig.

ENSONIQ

A%-10

Version 3 Operating System