Specifications

Audio Track Recording
Auto-Configuring for DiskTracks upon Booting
When the ASR-10 is configured for DiskTracks (ATRK PLAY/REC=SCSI), the SAVE GLOBAL
PARAMETERS command will store the active settings of the CONFIGURE AUDIO TRACKS
command with the Global Parameters on the O.S. disk.
Booting from an O.S. disk that has a DiskTrack configuration saved with its Global Parameters
will display the following prompt:
Pressing (CANCEL-NO) from the above prompt will abort the function. The ASR-10 will boot
normally, and will default to being configured for RAMTracks.
Pressing (ENTER-YES) from the above prompt will invoke the Auto-Configure function:
l The CONFIGURE AUDIO TRACKS command will be run, behind the scenes, using the
parameter settings that were saved with Global Parameters.
l The usual range of error messages will indicate any failure(s) in the process.
l If an error occurs, the ASR-10 will default to being configured for RAMTracks, (or for
DiskTracks playback only, depending on the error), and will enter flashing LOAD Mode after
the error message has been displayed.
l Auto-Configure will always use REC FILE=CURRENT BLKS (the current size of the existing
Temporary Record Files). You cannot Auto-Configure to a specific size REC FILE.
l If no errors have occurred, the following message will be displayed when the system has
been configured:
I:;:,
70
ENSONIQ ASR-10 Version 3 Operating System