Specifications
I
Audio Track Recording
I
Song Audio Track
Mixdown
Song Audio Tracks have the added bonus of recording AUDIO-MIX and AUDIO-PAN
information that will affect the playback of the Audio Tracks for full mixdown capabilities (the
Edit/Seq*Song, SONG ATRK REC parameter determines this). The Command/(audio) Track,
FILTER AUDIO EVENTS command can be used to remove AUDIO-MIX and AUDIO-PAN
events without removing the Audio Trigger events (see later in this document for a description of
the Audio Track commands).
Recording Audio-Mix and Audio-Pan information
1.
Select a song (refer to the ASR-10 Musician’s Manual for steps in creating a song).
2 Select an Audio Track that has AudioSample data (by pressing its (AUDIO TRACK) button).
3.
Press (EDIT), then
(SEQ.SONG]
, and use the Data Entry Controls to select SONG ATRK
REC=AUDIO.
4 press
m
once to change the display to SONG ATRK REC=MIX+PAN.
5.
Press
(m)
and while holding it down, press (PLAY).
At this point, you can change the mix or pan of the Audio Track, and it will be recorded.
6.
When the song is finished, select KEEP=NEW.
If you want to re-record your mixdown, you must first filter the audio events (see below).
How to Filter Audio
Mixdown
Events
1. Press
(w),
then (TRACK).
2 Use the Data Entry Controls to select the FILTER AUDIO EVENTS command:
/;;I,,,
3.
Press (ENTER-YES] to invoke the command. The display shows:
,,;,
4.
Use the (AUDIO TRACK A) and (AUDIO TRACK B) buttons to select the Audio Track that you
want to filter the audio events.
5. Press (ENTER-YES).
This page allows you to select either the AUDIO-MIX or the AUDIO-PAN events to erase
(which are selected using the
(p)
and
a
buttons or the Data Entry Slider).
6.
Press (ENTER-YES) to filter the selected Audio Track. The display momentarily shows
SHUFFLING DATA, then allows you to Audition the newly filtered Audio Track. If there are
no events to filter, the display momentarily shows NO DATA ON SOURCE TRACK.
7.
Select KEEP=NEW and press (ENTER-YES) to save the filtered version, or press
(CANCEL-NO) to abort the command.
ENSONIQ ASR-10 Version 3 Operating System
63