Manualshelf

Specifications

ManualsBrandsENSONIQ ManualsElectronic KeyboardASR-10
31323334353637383940
DAT Backup/Restore
I
DAT VERIFY
VERIFY can be performed as a separate step after a BACKUP or RESTORE. The backed-up
packets of data will be compared to the stored information on tape for accuracy and completion.
1. Press (COMMAND), then (SYSTEM-MIDI).
2 Press the (a) button until the display shows: DAT BACKUP/RESTORE. It is located
between CONFIGURE AUDIO TRACKS and BACKUP RESTORE.
3.
Press the (ENTER-YES] button and the display will show: MUST
ERASE
MEMORY OK?
4.
Press (ENTER-YES) and the display shows: DAT FUNCTION=RESTORE. Press the
m
until
the display shows: DAT FUNCTION=VERIFY.
5.
Press (ENTER-YES). The display shows: SCSI DRIVE=O. Use the
@
to select the same
number as the Priority/ID Number on your SCSI storage device.
6.
Press (ENTER-YES). The display shows: REWIND DAT-ENTER. Rewind your DAT tape.
7.
Press (ENTER-YES]. The display will show: PLAY DAT-ENTER. Press Play on your DAT
machine.
8.
Press (ENTEFPYES) . The display will flash: WAITING... until the ASR-10 receives the first
data from the DAT tape at which time the message VERIFY appears. (For a single tape
backup, skip to step 12.)
Note:
If more than one tape was required, the ASR-10 will compare the set number
and tape number to the one that was inserted. If the tape is from the wrong backup set
or is out of order, an error message will be displayed. Eject that tape and insert the
correct tape.
9.
After restoring the first tape the display shows: INSERT DAT 2-ENTER. Remove the first
tape and insert the next one.
10. Press ( ENTEROYES) . The display shows: REWIND DAT-ENTER. Rewind the DAT tape.
11. Press (ENTER-YES). PLAY DAT-ENTER appears. Press Play on the DAT machine.
12. Press (ENTER~YES) . The WAITING... message will be shown until the VERIFY message
replaces it.
Note:
Additional tapes will be requested until all of the backed-up data has been
verified. The display will show: VElUl? COMPLETE.
13. Press (ENTER-YES]. The display will show: COMMAND COMPLETED and the command
will be exited.
30
ENSONIQ ASR-10 Version 3 Operating System