Specifications

I
DAT Backup/Restore
1
DAT RESTORE
RESTORE will transfer the data on the backup tape(s) to the original or another SCSI Storage
Device. (This drive must be the same size as the drive that was backed up.)
1.
2
3.
4.
5.
10.
11.
12.
13.
14.
Important: If you abort during the RESTORE command, the data on the SCSI Storage Device
is no longer valid. If this should occur, protiptly reformat it to prevent further problems.
Press (COMMAND), then (SYSTEM*MIDI) .
Press the (a) button until the display shows: DAT BACKUP/RESTORE. It is located
between CONFIGURE AUDIO TRACKS and BACKUP RESTORE.
Press the (ENTER-YES) button and the display will show: MUST ERASE MEMORY OK?
Press (ENTER-YES) and the display shows: DAT FUNCTION=BACKUP. Press the a or
m until the display shows: DAT FLJXCTION=RESTORE.
Press (ENTER-YES). The display shows: SCSI DRIVE=O. Use the m to select the same
number as the Priority/ID Number on your SCSI storage device.
Press ( ENTEFPYES) . The display shows: REWIND DAT-ENTER. Rewind your DAT tape.
Press (ENTER-YES). The display will show: ERASE ALL DISK FILES?
Press (ENTER-YES) and the display will show: PLAY DAT-ENTER
Press Play on your DAT machine. The display will flash:
until the ASR-10 receives the first data from the DAT tape at which time the message
STOP
appears. (For a single tape backup, skip to step 12.)
Note: If more than one tape was required, the ASR-10 will compare the set number
and tape number to the one that was inserted. If the tape is from the wrong backup set
or out of order, an error message will be displayed. Eject it and insert the correct tape.
After restoring the first tape the display shows: INSERT DAT 2-ENTER. Remove the first
tape and insert the next one.
Press (ENTER~YES). The display shows: REWIND DAT-ENTER. Rewind your DAT tape.
Press (ENTEReYES). The prompt PLAY DAT-ENTER appears. Press Play on the DAT
machine.
Press (ENTEReYES) The WAITING... message will be shown until the RESTORE message
replaces it.
Note: Additional tapes will be requested by the prompts until all of the backed up
data has been restored. The display will show: RESTORE COMPLETE.
Press (ENTER-YES]. The display will show: COMMAND COMPLETED and the command
will be exited.
ENSONIQ ASR-10 Version 3 Operating System
29