Specifications

Instrument, Bank & Preset Parameters
When the parameter conversion is complete, the newly created Instrument will be selected
(yellow Selected LED lit) and can be played from the keyboard or via MIDI In. The following
page will be displayed:
NEW NAME Range: cl 2 character Patch name>
This parameter allows you to assign a 12 character ASR-10 Instrument name to the imported
Roland patch. This will default to the name of the imported Roland patch.
After editing the NEW NAME parameter as desired, pressing (ENTER-YES) will display the
following prompt:
l Pressing (CANCEL-NO) will exit the command. The following message will be momentarily
displayed:
l Pressing (ENTER~YES) will re-display the following page:
PATCH Range: 4 2 character patch name>
You may continue to select from among the Roland sampled sound patches available on the
selected Load Device, importing them as desired into any unused (empty) Instrument*Sequence
Track location. If you answered yes to the IMPORT ANOTHER? prompt, the last key range will
be retained, unless you change the selected Roland patch. If you change the selected patch, the
RANGE parameter will be reset to the full 88 note keyboard again.
Once imported, the Roland sampled sound patch(es) can be edited and saved as ASR-10
Instruments, as normal.
The settings for the LOAD DEVICE and PATCH parameters will be retained even after exiting
the command. They will be validated when the command is m-entered and as each page is
displayed; if they are no longer valid, the parameters will default to the lowest value.
12
ENSONIQ A%-10 Version 3 Operating System