Specifications

Instrument, Bank

Preset Parameters

New Command/Instrument Pages

COMMAND IMPORT NON-ASR SOUNDS

INST

Press (COMMAND)

(INSTRUMENT)‘/ scroll using’ the @) and cp) buttons

This command allows you to load sampled sounds via SCSI from Akai

SIOOOTM

Series and Roland

S700TM

Series formatted SCSI Storage Devices. Once imported, the non-ASR sampled sounds can

be edited and saved as ASR-10 Instruments, as normal. IMPORT NON-ASR SOUNDS is located

in the command list after DELETE INST EFFECT:

Note: This command requires an SP-3 SCSI Interface equipped ASR-10.

How to Use the IMPORT NON-ASR SOUNDS Command

Connect the ASR-10 SCSI interface to the Akai or Roland format SCSI Storage Device that you

want to load sampled sounds from.

Power on the SCSI Storage Device (let the drive spin up).

Power on the ASR-10.

Press

(COMMAND),

then (INSTRUMENT], and use the

and (p) buttons to locate the

IMPORT NON-ASR SOUNDS command.

The IMPORT NON-ASR SOUNDS command requires at least one unused (empty)

Instrument*Sequence Track location into which to load the Akai or Roland sampled

sound(s). If all eight Instrument*Sequence Tracks are occupied (red LED lit), pressing

(ENTEReYES]

to invoke the command will display “NO FREE INSTRUMENT,” and the

command will be aborted.

If there is at least one unused (empty) Instrument*Sequence Track location available,

pressing (ENTER-YES) while the IMPORT NON-ASR SOUNDS command is displayed will

show the following page:

U”EVICE

TYPE=XXXXXX

DEVICE TYPE

Range:

AKAI, ROLAND

Set the DEVICE TYPE parameter to the type corresponding to the format of the connected SCSI

Storage Device. This value will be retained until power-off, even after the command is exited.

ENSONIQ ASR-10 Version 3 Operating System