Specifications

I
SP-3 SCSI Interface Manual
I
Directory Commands
To Enter or Move Down into a Directory from the Front Panel
1. Press CLOAD) then (SYSTEM-MIDI), and use the a and a buttons to find the name of the
directory you wish to enter.
2
Press (ENTER-YES). This will open the new directory and allow you to view the contents of
that directory.
3. The display will show EXIT TO <dir name> where
“dir name” is the name of the parent
directory which you came down from.
4. You can also enter a directory by sending the ASR-10 a Program Change. Refer to “Receiving
Program Changes” when MIDI IN MODE = MULTI or MONO B in the Musician’s Manual.
Pressing the (a) and (p) buttons when the EXIT TO <dir name> (which is file 0 in the directory)
is displayed will show you the name of the current directory that you are located in.
Note: Once you have entered a directory from the Load/System*MIDI page, you
will not see any file names (except Macro, System Exclusive Files and other directories)
until you press one of the Page buttons, (INSTRUMENT), or (SECPSONG] . Remember to
select the file type you are seeking before concluding that you have not found the
correct directory.
To Exit from or Move Back Up from a Directory
1.
Press (LOAD] then (SYSTEM-MID~, and use the @ and m buttons until the ASR-10
displays EXIT TO <dir name> (where <dir name> is the name of the directory above the
currently selected directory).
Tip: Press (LOAD) then 00 to go directly to the EXIT TO entry.
2 Press (ENTER-YES). Depending on how many directories within directories you have, you
may need to press (m) a few times to return to the Root Directory level.
3. You can also exit from a directory by sending the ASR-10 MIDI Program Change $1. Refer to
“Receiving Program Changes” when MIDI IN MODE = MULTI or MONO B in the
Musician’s Manual.
Creating a New Directory
1.
Press (V), then (SYSTEM-MIDI) , and scroll to the CREATE DIRECTORY command.
2 Press (ENTER-YES). The display shows DIRNAME = NEWDIRECTORY.
3. You may edit the name of the new directory by using the Data Entry Slider and the
(ARROW) buttons. The name you choose should in some way reflect the files that will be
contained in the directory (see the Directory Recommendations section below).
4.
Once you have chosen a name, pressing (ENTER-YES) will create a new sub-directory in the
current directory. The display will show DISK COMMAND COMPLETED.
ENSONIQ A%-10 Version 3 Operating System
119