Specifications
I
Effect Parameters
I
REGEN (Chorus) Range: -99 to
+99
Controls the amount of feedback applied to the chorus. The sign of the value determines the
polarity of the feedback. Feedback accentuates the complexity of the ‘swept” signal.
REGEN
(Delay)
Range: -99 to
+99
Determines the amount of signal that will be fed from the output of the delay back
into
the input,
increasing the number of repeats in the delay. The sign of the value determines the polarity of
the regen.
REVERB MIX
Range:
0 to 99
This parameter controls the Dry/Wet mix of the Reverb. A setting of 0 offers no reverb.
SPEED
Range:
MIN or MAX
Determines how the rotary speaker will switch between slow and fast speeds. The behavior of
the switch accurately reflects an actual rotary speaker, taking time to speed up or slow down,
based on the value of the INERTIA parameter (see INERTIA description). Any effect modulator
can act as the SPEED controller. How the modulators will switch the rotor speed fall into two
categories:
l PATCH, FTSW2, SUSTN
-
These modulation sources toggle the rotor speed between MIN
and MAX. Every tune the modulation source moves from zero in a positive direction, the
rotating speaker effect changes speeds from MIN to MAX or MAX to MIN.
l KEYDN, VEL, KBD, XCTRL, PEDAL, PRESS, PBEND, WHEEL
-
These modulation sources
act like a switch to turn the fast rotor speed on or off. To reverse the polarity of the switch,
set SPEED
h4IN
faster than
h&IX.
SPEED MIN
Range: 0 to 130
Determines the rate of the rotary speaker when in the
“MIN”
setting. SPEED
MIIN
determines
the manual level for the rotary speaker rate when
SPEED=MTN,
or when the selected modulator
is at zero output level. Again, the higher the value, the faster the rate.
SPKR WET
Range: -99 to
+99
This parameter controls the volume of the rotating speaker only. Setting this parameter to +0 will
eliminate the rotating speaker portion completely.
TREB
Range: -99 to
+48
dB
Sets the treble amount of boost or cut applied to a 10 to 22K high-shelving filter.
TREBLE FC
Range:
1 to 20 KHz
Sets the center-frequency of the high-frequency parametric.
ENSONIQ ASR-10 Version 3 Operating System
105