Specifications
I
Effect .Parameters
I
INPUT TRIM
Range:
-24 to +0 dB
Allows you to adjust the input level trim to the EQs to eliminate the possibility of clipping
boosted signals.
LFO SPREAD
Range: 0 to 127
Controls the speed of the three left and three right oscillators relative to one another. A setting of
0 offers the same speed between the oscillators, whereas a setting of 127 would yield an octave
between 1 and 2, and 2 and 3.
MAX
Range: 0 to 130
Determines the rate of the rotary speaker when in the ‘MAX” setting. The higher the value, the
faster the rate.
MID
Range:
0 to 20000
Sets the center of the mid-frequency parametric.
MID BW
Range: 0 to 20K
This parameter is a bandwidth control that determines the width of the resonant peak at the mid-
frequency band. By lowering the value, you can produce a narrower bandwidth.
MID FC
Range:
0 to 9999 Hz
Sets the center of the mid-frequency parametric.
MID
Q
Range: 1 to 18
A bandwidth control that determines the width of the resonant peak at the center-frequency
band. By raising the value you can produce a narrower bandwidth.
OUT
Range: -99 to
+48
dB
Adjusts the output volume after the parametric EQ. With the LEVEL, GAIN BASS, and TREBLE
LEVEL set to high values, the OUTPUT parameter could be used to create a raspy distortion
effect. Negative values will decrease the output volume.
PAN
Range:
-99 to
+99
Determines the location of the dry signal in the stereo spectrum. A value of -99 is panned hard
left, and
+99
is hard right.
PREDELAY TIME
Plate Range: 0 to 300
msec
44EQ+DDL, 44DDL+CH+REV, 44DLYLFO+REV,
44EQ+REVERB,
44ROTO+REVRB Range: 0 to 150 msec
Controls the amount of time it takes for the input signal to be presented to the reverb. A value of
0 would offer no delay. The range is based in milliseconds.
REGEN
Range:
-99 to
+99
Determines the amount of signal that will be fed from the output of the left delay back into the
input, increasing the number of repeats in the delay. A setting of 99 would offer an infinite delay.
104
ENSONIQ ASR-10 Version 3 Operating System