Specifications

I
Effect Parameters
44 KHz Effect Descriptions and Variations
The Operating System disk contains 12 new 4.4 KHz effect algorithms specially designed for the
ASR-10. This section will:
l show the name of each effect as it appears on the display (shown inside the black header),
l list the available preprogrammed variations (shown immediately below the effect name),
l describe the effect,
.
show the signal routing diagram (if applicable), and
l list the names of parameters that you can adjust.
At the end of the section is an alphabetized list of all the parameters and what they do.
11 LUSH REVERB 12 STANDARD REVERB 13 MEDIUM REVERB 14 LONG REVERB
1 LUSH REVERB 12 STANDARD REVERB 13 MEDIUM REVERB
4 LONG REVERB
I
1 AMBIENT REVERB
I
2 SLAP REVERB
I
3 SHORT REVERB
I
4 PERC REVERB
I
A plate reverb takes the vibrations from a metal plate and uses them to create a metallic-sounding
reverb. 44LUSH PLATE is a 44 KHz small plate reverb offering early reflections; 44LUSH PLAl2
is a larger 44 KHz plate reverb effect; 44F’ERC PLATE is a 44 KHz plate reverb optimized for
drum and percussion sounds. In general, small plate reverbs are used for drums and percussion,
while large plate reverbs are used to enhance a vocalist’s performance.
o-
Left
Predelay
Definition
Main
cl, r+n, ltr
1 IrBW Control1 1 1
Right
o-
Reverb Signal Routing (applies to all plate reverb effects)
DECAY TIME
PREDELAY TIME
HF DAMPING
DEPTH
DEFINITION
DIFFUSION (1 & 2)
* not available within 44LUSH PLATZ
DETUNE RATE ER LEVEL (L & R)
f not available within 44LUSH PLATZ
Reverb Parameters (apply to all plate reverb effects, except where noted)
ENSONIQ ASR-10 Version 3 Operating System
91