Specifications
Troubleshooting
S
G
#
G
T
E
p1
p
G
1:
I
PI
E
v
R
R
I
E
S
This message appears when you try to record Song Audio Tracks in a song
made up of sequences containing different Tempos and Time Signatures.
Song Audio Tracks can only be recorded in songs made up of sequences of
like tempos and time signatures.
STOP SELIUEMCER FIRST
When auditioning a DiskTrack recording, you cannot dynamically switch
between OLD and NEW on the Audition page while the sequencer is in play. If
you try, you will get this message.
U:~O~~ECTED
SCSI DEV
A SCSI storage device that was detected by the
AS&l
0 at
bootup
is no longer
connected or turned on, or the selected Load Device does not exist. The
ASR-10 will be configured for ATRK PLAY/REC=SCSI, but REC SCSI
DRIVE=NONE
(i.e., SCSI playback only) and Buffers have been allocated.
Check the cable connections from your SCSI Storage Device to the ASR-10.
/IFvyctake
sure you selected the same Priority/ID number as the storage
L’SE
SI1R::ER RrlCUI’I:
The SCSI BUFFERS size selected in the CONFIGURE AUDIO TRACKS
command is too large to fit in available RAM. After this message is displayed,
the ASR-10 Audio Track configuration will be left unchanged. Choose a
smaller value and try again.
:‘RITIPIG .
During RESTORE or VERIFY, if it appears indefinitely, the backup on the DAT
is damaged so the ASR-10 cannot recognize it, or the DAT contains no
ASR-
10 BACKUP at all. Press (CANCEL-NO] to abort the command.
Check that the right and left LED displays are responding equally on the DAT
machine. If not, remove the tape and check to see that you are using the
correctly labeled tape. You may need to BACKUP again if the data is
damaged.
llR217G
DRT I”1L’flBER The wrong number tape from the correct set has been inserted. You will be
given the chance to insert the correct tape after pressing (ENTER-YES).
Eject the tape and insert the proper tape from the set.
1IROrlG
CEVICE TYPE
If the selected Load Device is not formatted, or is the wrong format, the
following error message will be displayed, and the command will be aborted.
~IRGI~G
SIZE DISK
This message appears when you use the COPY FLOPPY DISK command and
try to copy data from an HD disk (High Density disk) to a DD disk (Double
Density disk), or vice versa.
Note: You may see some of these error messages if you’re performing a DAT
BACKUP/RESTORE and you’re operating your DAT machine in a humid
environment. In this case, the data on the tape may be good. We strongly recommend
operating your DAT machine in a cool, climate controlled environment.
90
ENSONIQ ASR-10 Version 3 Operating System