Programming instructions

Section 11 — WaveSample and Layer Parameters ASR-10 Musician’s Manual
24 Edit/Layer Parameters
Command/Layer Page
These commands allow you to create, copy, and delete whole layers.
CMD
CREATE NEW LAYER
LAYER
Press Command / Layer / 0
Use this command to create a new layer in the currently selected instrument.
Select CREATE NEW LAYER.
Press Enter•Yes. The display reads LAYER ## CREATED.
CMD
COPY LAYER
LAYER
Press Command / Layer / 1
Use this command to copy an existing layer and all the WaveSamples in it, either within an
instrument or from one instrument to another.
Select COPY LAYER. The display reads TO INST=UNNAMED INST.
Select the destination instrument. Press Enter•Yes.
Select COPY=PARAMS ONLY/PARAMS+DATA. It is a good idea to choose PARAMS ONLY
when copying a layer within the same instrument, allowing the wave data to be shared. This
will conserve memory. However, always choose PARAMS+DATA when copying a layer from
one instrument to another, or else the destination instrument will not contain the wave data
when it is saved to disk, and subsequently reloaded.
Press Enter•Yes. The display reads LAYER ## CREATED.
Note: When STEREO LAYER LINK= ON, this command will also copy the companion layer. However,
in order for this to work properly, there must be two undefined adjacent layers available.
CMD
DELETE LAYER
LAYER
Press Command / Layer / 2
Use this command to delete a layer in the currently selected instrument. This will delete all
WaveSamples in the selected layer as well.
Choose the layer you want to delete.
Select DELETE LAYER.
Press Enter•Yes. The display reads DELETE LAYER ##.
Press Enter•Yes or Cancel•No.
Note: If you get the message NO EDIT LAYER SELECTED, simply press Edit and select the layer you
want to copy or delete, and then proceed with the command.