User guide

BrightEye 11-HD HD/SD SDI to Analog Converter
BrightEye-8
ADJUSTING PARAMETERS FROM THE FRONT PANEL
Use the Mode, Right Arrow, and Left Arrow buttons to select and adjust
parameters from the front panel.
Pressing the Mode button activates the front panel for editing and tabs between
each section of editable parameters.
Pressing the Right Arrow or Left Arrow advances the selection within a given
section of parameters, or increases (Right Arrow) or decreases (Left Arrow) the
value of a selected parameter.
The LED of an edited parameter will blink for 15 seconds, after which time its value is
stored in memory. If power is interrupted before this 15 second timeout period has
elapsed, the edited state will not be not saved.
The controls and their indicators are described below:
Output
Selects the video output format from the following choices:
Cpst – NTSC or PAL Analog Composite Video with simultaneous
S-Video Y/C. (Use a standard BNC-to S-Video adapter on the two inputs.)
SD only.
SMPTE – Component Video in SMPTE format
Beta – Component Video in Beta format
RGB – Component Video in RGB format
Gain
This control adjusts the gain of the analog video signals of the converter. The
right arrow increases the gain; the left arrow decreases it. The Gain indicator
illuminates green when the gain is set to its nominal or unity setting.
Setting Gain to unity ensures correct analog output levels from an analog input
source that is at proper level itself. The Gain indicator illuminates red if the
control is adjusted higher or lower than its nominal setting. To reset gain to its
nominal setting (green) press both arrows simultaneously.
NOTE: