User guide

BrightEye 75 HD/SD Analog to Digital Converter and Analog Audio Embedder
BrightEye 75 - Page 14
Config Menu
Use the Config menu to set the following output conditions for the output signal:
•Signal Mute– select the condition for muting the output signal to
No Muting, Mute On Noise, or Freeze on Noise.
•Analog Setup– set to On if setup is present on the analog input, or Off if
no setup is present.
•V Blanking– set the vertical blanking to Narrow (NTSC: lines 1-9,
PAL: lines 1-6) or Wide (NTSC: lines 1-20, PAL: lines 1-22).
•Comb Mode– set the comb filtering to Comb On or Comb Off.
•Peak Indicator– selects the amount of headroom used in determining
peak indication. Chose Clipping, 2 dB Headroom, 4 dB Headroom,
6 dB Headroom, 8 dB Headroom, or 10 dB Headroom.
•Dig Ref Level– selects the digital reference output level. Choose -20 dBFS or
-18 dBFS.
•Anlg Ref Level– selects the analog audio input level for embedding.
Choose -10 dBu or +4 dBu.