User guide

TM
BrightEye 54
BrightEye 54 - Page 11
USING THE BRIGHTEYE CONTROL APPLICATION
The BrightEye PC and BrightEye Mac applications included on CD-ROM are
designed to allow you to configure and control the BrightEye 54 from a personal
computer. Installation and instructions for using this software application are
given in the PDF manual on disk. If the BrightEye 54 is connected to a computer
running this software, the following menus are available for controlling and
monitoring the unit:
Test Pattern Menu
•Test Pattern– select the type of test pattern from the pulldown: Black,
Flat 20%, Flat 80%, 75% Bars, 100% Bars, SMPTE Bars, Safe Title,
Sweep, Mono Sweep, Multi Burst, Mono Burst, or User (defined under
User Pattern).
•User Pattern– selects the pattern displayed when Test Pattern is set to
User. This pulldown lets you chose between: Pathological, Pulse and
Bar, Ramp, Digital Blanking, Analog Blanking, Interlace,
Crosshatch, and Unit Circle.
•Y, Cr, and Cb Channels– these check boxes allow you to selectively
disable the output in particular luminance and color channels.
•ID and ID Mode– these pulldowns control signal identification. Use ID to
turn signal identification On or Off. ID Mode selects between Slate Only,
Cyclops Only,or Slate & Cyclops. The content of the ID Slate can be
controlled from the Config Menu.
•Tone and Tone Mode – these pulldowns control audio tone generation.
Tone turns tone generation On or Off. Tone Mode selects the style of tone
generated. Select between Continuous, Pop
, or Beep.
•Embedding– turning this control On embeds the audio test tone into the
SDI output. Turning it Off, does not embed the audio test tone.