User guide

TM
BrightEye 5
5
BrightEye 55 - Page 13
Config Menu
Use the Config menu shown below to set the following parameters:
•Standard– select the output standard for SDI and composite video. This
pulldown lets you chose between: NTSC (525) and PAL (625).
•HD Standard– select the HD Tri Level Sync standard. This pulldown lets
you choose between: 1080i, 720p, 1080p, or 1080sF.
•Setup– turn Setup On or Off for 525 60Hz signals.
•Slate Text- the contents of this text field will be displayed in the ID Slate.
Enter up to 19 characters.
•Dig Ref Level– select the digital audio reference level. This pulldown lets
you choose between: -18dBFS or -20dBFS.
•Analog Ref Level– select the analog audio reference level. This pulldown
lets you choose between: -10 dB, -6 dB, -4 dB, 0 dB, or +4 dB.
•TLS Framerate– this control allows selection of the Tri Level Sync frame
rate output between 23.98/50/59.94 Hz and 24/30/60 Hz. Refer to the
discussion of this functionality in the FUNCTIONAL DESCRIPTION at
the front of this document.
•Freq Adjust– this control temporarily enables the Freq Adjust control.
When this control is set to Allowed the user has 20 seconds to begin
adjusting the internal clock frequency, after 20 seconds this Freq Adjust is
disabled.
•Freq Adjust– this control allows the internal timing source to be adjusted.
See the ADJUSTMENTS section of this manual for more details and the
adjustment procedure.