User guide

BrightEye 55 Genlockable SPG/TSG
BrightEye 55 - Page 10
HD Sync
The currently selected HD Tri Level Sync format (1080i, 720p, 1080p,or1080sF)
is illuminated green. One of two different Tri Level Sync (TLS) frame rates can be
selected in the Config menu of the BrightEye Control application as
23.98/50/59.94 (the most commonly used, default value) or 24/30/60 (for special
applications such as film).
Pwr (Power)
Illuminates green when power is applied to the unit and the internal voltage
regulator is functioning correctly.
ADJUSTING PARAMETERS FROM THE FRONT PANEL
Use the Mode, Right Arrow, and Left Arrow buttons to select and adjust
parameters from the front panel.
Pressing the Mode button activates the front panel for editing and tabs between
each section of editable parameters.
Pressing the Right Arrow or Left Arrow advances the selection within a given
section of parameters, or increases (Right Arrow) or decreases (Left Arrow) the
value of a selected parameter.
The LED of an edited parameter will blink for 15 seconds, after which time its value is
stored in memory. If power is interrupted before this 15 second timeout period has
elapsed, the edited state will not be not saved.
The LED indicators will report the following:
•Std (Standard) select– currently selected video output standard
blinks.
•Ref– illuminates green when a valid NTSC or PAL reference is
detected. Off when no reference is detected.
•Video– currently selected video pattern (or pattern group) output
blinks.
•Slate on/off– blinks quickly when ID slate is enabled, slowly when
disabled.
•Tone on/off– blinks quickly when tone is enabled, slowly when
disabled.
•HD Sync select– currently selected HD Tri Level Sync format
blinks.
The controls and their indicators are described below:
Std (Standard)
This control selects the video output standard with the following choices:
NTSC – 525 NTSC standard
PAL – 625 PAL standard
NOTE: