Install Guide

Ensemble Communications Inc.
4-4 Operator’s Guide to the Fiberless System
Figure 4-1. Pole Mount Assembly
Lightning Suppressor
Installation
Caution
It is not possible to guarantee that lightning protection will be
100 percent effective against a direct lightning strike.
Note A lightning suppressor is not shipped with the ODU. See page 3-10 for
the Ensemble-recommended lightning suppressor.
Install one suppressor as close as possible to the point at which the
cable enters the building. Install another suppressor as close as
possible to the ODU. Figure 4-2 and Figure 4-3 show this
installation.
• Orient the grounding stud on the suppressor as shown in
Figure 4-2.
• Use both a lock washer and flat washer with each bolt.
• Attach ground strap between the ground stud on the suppres-
sor and an antenna-mounting bolt as shown, making sure that
pole is grounded and connections are clean.
(1) Mast
(3) Mounting
Clamps
(4) Mounting
Rack
(6) Elevation
Markers
(5) Alignment
Bracket
(7) Azimuth
Alignment Bolt
Vertical Alignment
Bolt
(2) Mounting
Bolts