Install Guide

Ensemble Communications Inc.
4-2 Operator’s Guide to the Fiberless System
Unpacking and Inventory
• Unpack the equipment on a flat, clean surface at the installa-
tion site.
• Check the items received against the packing list and a copy of
the purchase order to ensure that the order is complete.
• Check that the ODU has the frequency band and polarity
ordered. This information is on the manufacturer label.
• Inspect all components to determine that they are not dam-
aged. If a component appears to be damaged or is missing, con-
tact your shipper and Ensemble Customer Service
immediately.
• Save all packing materials.
Note Ensemble Customer Support is available at 888-710-8910.
ODU Components The following components comprise a baseline ODU:
• Outdoor radio-antenna unit (ODU)
• Pipe or wall mount kit
Note The type of mount is specified at the time of ordering. Mounts may be
ordered in either standard or metric measure.
Ancillary Materials The following materials are required to install the base station
ODU, depending on your site specific requirements. See “Ancillary
Equipment” on page 10 for a list of recommended materials and
manufacturers. If in doubt, check with Ensemble Customer
Service.
• 3M type 33 electrical tape
• 3M electrical coating (PN 054007-1483)
• Wire ties
• Black nylon wire ties for outdoor use
• RG-6 75 Ohm cable (Belden 9248)
• TNC connectors and connector kit
Tools for Installation • 1/2-inch and 7/16-inch sockets with wrench
• 2-inch extension (optional)