Install Guide

Ensemble Communications Inc.
Installing the Base Station Indoor Equipment 5-5
Interface Card Installation
WARNING
Wear a grounded wrist strap when handling the interface
cards. Failure to exercise ESD precautions can damage the
interface cards.
Caution
Before initially inserting interface cards, ensure the circuit
breakers supplying both the A and B power buses are turned
off.
Caution
Populate any empty slots with the supplied blank cards so air-
flow is properly directed among the cards.
Install cards in slots as listed in Table 5-1. Slots and cards are keyed
to prevent installing them in the wrong slot.
1. Position and slide the interface card into the slot until it is
seated (See Figure 5-2).
Figure 5-2. Base Station Card Positioning
2. Press down on the card lever until it snaps shut.
3. Then tighten the screws at the top and bottom of the card
4. Repeat this process for each interface card to be installed.
Note When seated, a mechanical latch locks the interface cards lock into
place.