User's Manual

Ensemble Communications Inc.
6-2 Operator’s Guide to the Fiberless System
Unpacking and Inventory
• Unpack the Fiberless 320 CPE and CPE ODU on a flat, clean
surface at the installation site.
• Check the items received against the packing list and a copy of
the purchase order to ensure that you have received your com-
plete order.
• Check that the CPE ODU has the frequency band that was
ordered. This information is on the manufacturer label and
should match the network plan.
• Inspect all components to be sure they are not damaged. If a
component appears to be damaged or is missing, contact your
shipper and Ensemble Customer Service immediately.
• Save all packing materials.
Note Ensemble Customer Support is available at 888-710-8910.
Indoor Equipment
Components
• Fiberless 320 indoor unit with pre-installed subscriber interface
cards (SICs). Cards may be of the following types:
• 4-port T1
• 6-port 10/100BaseT
Note Subscriber interface cards are specified at the time of ordering and are
factory-installed.
Note Release 1.0 does not support V.35 SICs.
• Power cord for AC-powered model
ODU Components • Fiberless CPE ODU with frequency band as specified at time of
ordering. See page A-1 for specifications.
Note CPE ODU frequency is specified at the time of ordering and is factory-
configured.
• ODU wall mount or pole mount kit
Note Mount type is specified at the time of ordering.
• Ground strap
Installation Materials • 3M type 33 electrical tape
• 3M electrical coating (PN 054007-1483)
• RG-6 Belden 9248 75 Ohm coaxial cable for outdoor use