User's Manual

Ensemble Communications Inc.
6-12 Operator’s Guide to the Fiberless System
Caution
If you power off the CPE, wait five seconds before turning on
the power again.
Antenna Alignment
The following sections describe how to align the antenna.
Figure 6-8 illustrates the assembly and its alignment rods.
Figure 6-8. Antenna Adjustments
DC Voltage
Measurement
• Connect a BNC cable to the ODU alignment port (BNC connec-
tor) as shown in Figure 6-9.
• Connect the other end of the BNC cable to the banana plug.
• Turn on the DVM and set it to measure DC voltage. Make note
of the voltage reading on the DVM.
• Connect the banana plug to the digital voltage multimeter
(DVM).
Vertical alignment rod
Horizontal alignment rod