User Manual

User’s Manual
268
Parameter Description
Enable
Enable the email function.
There might be risk of sending data to specified email address after it is
enabled.
SMTP Server Enter the address of SMTP server of sender’s email account.
Port
Enter the port value of SMTP server. The default value setting is 25. You
can enter the value according to your actual situation.
Username
Enter the user name and password of sender’s email account.
Password
Anonymous If enable the anonymity function, you can login as anonymity.
Receiver
In the Receiver list, select the number of receiver that you want to
receive the notification. The Device supports up to three mail receivers.
Email Address Enter the email address of mail receiver(s).
Sender
Enter the sender’s email address. It supports maximum three senders
separated by comma.
Subject
Enter the email subject.
Supports Chinese, English and numerals. It
supports maximum 64
characters.
Attachment
Enable the attachment function. When there is an alarm event, the
system can attach snapshots as an attachment to the email.
Encryption Type
Select the encryption type: NONE, SSL, or TLS.
For SMTP server, the default encryption type is TLS.
Sending Interval (sec.)
This is the interval that the system sends an email for the same type of
alarm event, which means, the system does not send an email upon any
alarm event.
This setting helps to avoid the large
amount of emails caused by
frequent alarm events.
The value ranges from 0 to 3600. 0 means that there is no interval.
Health Mail
Enable the health test function. The system can send a test email to
check the connection.
Sending Interval
(Min.)
This is the interval that the system sends a health test email.
The value ranges from 30 to 1440. 0 means that there is no interval.
Test
Click Test to test the email sending function. If the configuration is
correct, the receiver’s email account will receive the email.
Before testing, click Apply to save the settings.
Click Apply to complete the settings.
5.15.1.8 Configuring UPnP Settings
You can map the relationship between the LAN and the WAN to access the Device on the LAN through
the IP address on the WAN.