User Manual

User’s Manual
189
Parameter Description
Send Email
Select the Send Email check box to enable the system to send an
email notification when an alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > EMAIL.
Record Channel
Select the channel(s) that you want to record. The selected channel(s)
starts recording after an alarm event occurs.
The recording for intelligence event and auto recording function must
be enabled. For details, see "5.1.4.9 Configuring Recorded Video Storage
Schedule" and "5.9.1 Enabling Record Control."
PTZ Linkage
Click Setting to display the PTZ interface.
Enable PTZ linkage actions, such as selecting the preset that you want
to be called when an alarm event occurs.
To use this function, the PTZ operations must be configured. For details,
see "5.4 Controlling PTZ Cameras."
Post-Record
Set a length of time for the Device to delay turning off recording after
the alarm is cancelled. The value ranges from 10 seconds to 300
seconds.
Tour
Select the Tour check box to enable a tour of the selected channels.
 To use this function, the tour setting must be configured.
 After the tour is ended, the live view screen returns to the view
layout before tour started.
Picture Storage
Select the Picture Storage check box to take a snapshot of the
selected channel.
To use this function, make sure the snapshot function is enabled for
Intel in Main Menu > STORAGE > Schedule > Picture Storage.
Video Matrix
Select the check box to enable the function. When an alarm event
occurs, the video output port outputs the settings configured in "Main
Menu > DISPLAY > Tour > Sub Screen."
 Not all models support this function.
 The extra screen must be enabled to support this function.
Buzzer Select the check box to activate a buzzer noise at the Device.
Log Select the check box to enable the Device to record a local alarm log.
Alarm Tone Select to enable audio broadcast in response to a face detection event.
Click OK to save the settings.
Select the Enable check box, and then click Apply.
The tripwire detecting function is active. When the target object crosses the tripwire in the
defined direction, the system activates alarms.