User Manual

User’s Manual
160
Click Apply to complete the settings.
5.10.5.2 Configuring Network Event Settings
Select Main Menu > ALARM > Exception > Network.
The Network interface is displayed.
Configure the settings for the Network event.
Parameter Description
Event Type
In the Event Type list, select Offlice, IP Conflict, or MAC Conflict as the
event type.
Enable Enable or disable the Network event detection function.
Alarm-out Port
Click Setting to display setting interface.
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
External Alarm: Enable alarm activation through the connected alarm
box.
Wireless Siren: Enable alarm activation through devices connected by
USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Show Message
Select the Show Message check box to enable a pop-up message in your
local host PC.
Send Email
Select the Send Email check box to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > Email.