User Manual

User’s Manual
159
Configure the settings for the HDD event.
Parameter Description
Event Type
In the Event Type list, select No Disk, Disk Error, or Low Space as the event
type.
Enable Enable or disable the HDD event detection function.
Alarm-out Port
Click Setting to display setting interface.
Local Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
Extension Alarm: Enable alarm activation through the connected alarm
box.
Wireless Siren: Enable alarm activation through devices connected by
USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Show Message
Select the Show Message check box to enable a pop-up message in your
local host PC.
Report Alarm
Select the Report Alarm check box to enable the system to upload the
alarm signal to the network (including alarm center) when an alarm event
occurs.
Send Email
Select the Send Email check box to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > Email.
Buzzer Select the check box to activate a buzzer noise at the Device.
Log Select the check box to enable the Device to record a local alarm log.
Alarm Tone
Select to enable audio broadcast/alarm tone in response to a HDD alarm
event.