User Manual

User’s Manual
144
Parameter Description
Send Email
Select the Send Email check box to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > Email.
Record Channel
Select the channel(s) that you want to record. The selected channel(s) starts
recording after an alarm event occurs.
The recording for local alarm recording and auto recording must be enabled.
For details, see "5.1.4.9 Configuring Recorded Video Storage Schedule" and
"5.9.1 Enabling Record Control."
PTZ Linkage
Click Setting to display the PTZ interface.
Enable PTZ linkage actions, such as selecting the preset that you want to be
called when an alarm event occurs.
Post Record
Set a length of time for the Device to delay turning off recording after the
alarm is cancelled. The value ranges from 10 seconds to 300 seconds, and
the default value is 10 seconds.
Tour
Select the Tour check box to enable a tour of the selected channels.
Picture Storage
Select the Snapshot check box to take a snapshot of the selected channel.
To use this function, select Main Menu > CAMERA > Encode > Snapshot,
in the Type list, select Event.
Sub Screen
Select the check box to enable the function. When an alarm event occurs,
the extra screen outputs the settings configured in Main Menu > DISPLAY >
Tour Setting > Sub Screen.
 Not all models support this function.
 To use this function, extra screen shall be enabled.
Video Matrix
Select the check box to enable the function. When an alarm event occurs,
the video output port outputs the settings configured in Main Menu >
DISPLAY > Tour Setting.
Not all models support this function.
Buzzer Select the check box to activate a buzzer noise at the Device.
Log Select the check box to enable the Device to record a local alarm log.
Click Apply to complete the settings.
 Click Default to restore the default setting.
 Click Copy to, in the Copy to dialog box, select the additional channel(s) that you want
to copy the local alarm settings to, and then click Apply.