User Manual

User’s Manual
115
Configure the settings for the manual adding device parameters.
Parameter Description
Channel
In the Channel list, select the channel that you want use on the Device to
connect the remote device.
Manufacturer
In the Manufacturer list, select the manufacturer of the remote device.
IP Address
In the IP Address box, enter the IP address of remote device.
The default is 192.168.0.0 which the system cannot connect to.
RTSP Port
The default value setting is 554. You can enter the value according to your
actual situation.
HTTP Port
The default value setting is 80. You can enter the value according to your
actual situation.
If you enter other value, for example, 70, and then you should enter 70
after the IP address when logging in the Device by browser.
TCP Port
The default value setting is 37777. You can enter the value according to
your actual situation.
User Name Enter the user name of the remote device.
Password Enter the password of the user for the remote device.
Remote CH No.
Enter the remote channel number of the remote device that you want to
add.
Decoder Strategy
In the Decoder Strategy list, select Default, Realtime, or Fluent.
Protocol Type
If the remote device is added through private protocol, the default
type is TCP.
If the remote device is added through ONVIF protocol, the system
supports Auto, TCP, UDP, or MULTICAST.
If the remote device is added through other manufacturers, the
system supports TCP and UDP.
Encryption
If the re
mote device is added through ONVIF protocol, enabling the
Encryption check box will provide encryption protection to the data being
transmitted.