User Manual

3. The event triggered and park action related PTZ movement will be locked for 180 seconds
after you enter the intrusion detection interface. Optionally, you can click the
button to manually activate the movement, or lock the movement
when the button turns to by clicking it.
4. Select a region.
5. Draw area.
1) Select the Region No.in dropdown list.
2) Click to draw a rectangle on the image as a defense region.
3) Click on the image to specify a corner of the rectangle, and right-click the mouse after
four corners are configured.
6. Configure the parameters for each defense region separately.
 Threshold: The threshold for the time of the object loitering in the region. If you set the
value as 0, alarm is triggered immediately after the object entering the region.
 Sensitivity: The value of the sensitivity defines the size of the object which can trigger
the alarm, when the sensitivity is high, a very small object can trigger the alarm.
 Detection Target: You can select human, vehicle, or other object as the detection
target. If Human is selected, only human beings will be identified as detection objects,
so as Vehiclthe other two optione.
Note:
For network cameras, regions can be set simultaneously before clicking Save button. For
speed domes, you need to set 1 region and save it. Then continue to set and save the next
region.
7. Click tab to enter the arming schedule setting interface. The time schedule
configuration is the same as the settings of the arming schedule for motion detection. Refer
to Section 5.2.1 Configuring Motion Detection for more details.
8. Click tab to select the linkage method taken for intrusion detection, Notify
Surveillance Center, Send Email, Upload to FTP/Memory Card/NAS, Trigger Alarm Output,
Trigger Recording, Smart Tracking, White Light Flashing, and Audible Warning are selectable.
 For speed dome, you can also choose to link smart tracking. Smart Tracking should be
configured in advance.
 For certain models, White Light Flashing and Audible Warning are supported. Refer to
Section 5.2.1 Configuring Motion Detection for detailed configuration.
9. Click to save the settings.
Formatted: Default Paragraph Font
Formatted: Font: Not Bold, Not Italic