User Manual

Trigger one or more external alarm outputs when an event occurs.
Note:

To trigger an alarm output when an event occurs, refer to Section 5.2.4 Configuring Alarm
Output to set the alarm output parameters.
 Trigger Recording
Record a video when an event occurs.
Note:
You have to set the recording schedule to realize this function. Refer to Section 5.1.1
Configuring Recording Schedule for settings the recording schedule.
5.2.2 Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm actions when the lens is covered.
Steps:
1. Enter the Video Tampering settings interface :
Configuration > Event > Basic Event > Video Tampering
Tampering Alarm
2. Check the checkbox to enable the tampering detection.
3. Set the tampering area.
4. Set Sensitivity level. Higher level means easier to trigger.
5. Click tab to enter the arming schedule setting interface. The arming
Formatted: Indent: Left 3.54 ch
Formatted: TOC 6, Indent: Left 3.54 ch, Line spacing: single,
No bullets or numbering
Formatted: TOC 6, Justified, Left 0 ch, Bulleted + Level: 1 +
Aligned at: 0.2" + Indent at: 0.53"