User Manual

HD-TVI Speed Dome User Manual

Y - M - D 19 01 05

H - M - S 15 08 05

IRIS +: OK

IRIS -: CANCEL

Figure 3-5 Set the System Time

 Zero Angle Configuration

Purpose:

You can define the zero angle of the speed dome on the ZERO ANGLE submenu.

Steps:

1. Move the cursor to ZERO ANGLE using the direction buttons and click IRIS+ to enter.

2. Click the left/right/up/down direction buttons to adjust the monitor angle of the speed dome.

3. Click IRIS+ button to confirm the settings and exit.

 Display Settings

Purpose:

You can enable or disable the on-screen display of PTZ movements, time, preset, zone, address,

error rate, and fan/heat show, etc.

Steps:

1. Move the cursor to DISPLAY SETTINGS using the direction buttons and click IRIS+ to enter it.

2. Move the cursor to the target item and click IRIS+ and click up/down direction buttons to

choose each display mode as ON or OFF, and define each display time as 2 seconds, 5 seconds

or 10 seconds.

3. Click IRIS+ button to confirm the settings.

If you enable the OSD for both ZOOM SHOW and P/T ANGLE, while calling a preset, the preset

No. will be displayed on the screen till the preset scene passes.