Manual

Network Camera User Manual

Check the “Enable address filtering” check box.

Select “Block/Allow the following address”, IPv4/IPv6/MAC and then enter IP address or

MAC address in the address box and click the “Add” button.

4.7.4 Security Management

Go to ConfigSecuritySecurity Management as shown below.

In order to prevent against malicious password unlocking, “locking once illegal login”

function can be enabled here. If this function is enabled, login failure after trying six times

will make the login interface locked. The camera can be logged in again after a half hour or

after the camera reboots.

For some specified versions, anonymous login with a private protocol can be enabled here. If

this function is enabled, enter http://host:port/Anonymous/1[2/3] (eg.

http://192.168.226.201:80/Anonymous/1) via web browser to access the camera. 1 indicates

main stream; 2 indicates sub stream; 3 indicates third stream. Only video can be viewed by

this means and no other operations can be done. If no such function, please skip the

instruction.

4.8 Maintenance Configuration

4.8.1 Backup and Restore

Go to ConfigMaintenanceBackup & Restore.