Manual

42
Network Camera User Manual
2. Enable the face detection function and then select auto detection or interval detection.
Save Source Information: if checked, the whole picture will be saved to a local PC or an SD
card when detecting a face.
Save Face Information: if checked, the captured face picture will be saved to a local PC or an
SD card when detecting a face.
Note: To save images to a local PC, please enable the local face information storage first
(ConfigSystemLocal Config). To save images to an SD card, please install an SD card
first.
2. Set alarm holding time and alarm trigger options. The alarm trigger setup steps are the
same as motion detection setup. Please refer to motion detection chapter for details.
3. Set alarm detection area.
Click “Draw Area” and drag the border lines of the rectangle to modify its size. Move the
rectangle to change its position. Click “Stop Draw” to stop drawing the area. Click “Clear” to
clear the area. Then set the maximum value and the minimum value of the detected face.
4. Set the schedule of the face detection. The setup steps of the schedule are the same as
schedule recording setup (See Schedule Recording).
5. Advanced configuration.
Face Exposure: When the brightness of the captured face is not enough, it can be enabled.
White Light Mode: “OFF”, “Manual” or “Auto” is optional. In low illumination condition,
this mode can be enabled. (Only some models support this function)
Max. detection face
Min. detection face
These two face
contours will change as
the set minimum and
maximum value.