Manual

40
Network Camera User Manual
Click “Draw Area” and drag the mouse to draw a rectangle area. Drag the four border lines or
the four corners of the rectangle to modify its size. Click “Stop Draw” to stop drawing the
area. Click “Clear” to clear the area. Click and drag the arrow or the other end of the arrow
line to change the people entrance direction.
The area drawn yellow box is the detected area. The size range of the head image (width or
height) shall occupy from 1/5 to 1/2 of the drawn detection area. The direction of the red
arrow is entrance.
After the people counting detection is set successfully, go back to the live view interface to
view the counting results. Please refer to the following picture.
※ Configuration requirements of camera and surrounding area
1. Cameras must be installed in the area with stable and adequate light sources.
2. The background color (like floor color) should be light color.
3. The lens of the camera should be adjusted straight down to ensure that the whole head of
the people can be captured.
4. The installation height of the camera depends on the actual focal length of the lens. The
entrance/exit in the image should take up over a half of the width of the entire image and the
head of a single person should account for about 1/5 of the height of the entire image.