Manual

39
Network Camera User Manual
1. Go to ConfigEventPeople Counting. Please refer to the following picture.
2. Enable the people counting detection.
3. Set “Detection Sensitivity”, “Entrancing Threshold”, “Departing Threshold”, “Staying
Threshold”, “Counting Period”, “Alarm Holding Time” and so on.
Counting Period: All, daily, weekly and monthly are optional.
Counting Reset: The current number of people counting will be cleared and the current
counting period will restart by clicking “Reset” button.
If the number of people exceeds the pre-defined threshold value (the default value is 500; the
maximum value is 655350), alarms will be triggered.
When someone passes the detected area, it will take 1 ~5 seconds to complete the detection of
people counting according to different scenes.
Set alarm trigger options. The setup steps are the same as motion detection. Please refer to
motion detection chapter for details.
4. Set the area of the people counting. Click the “Area” tab to go to the area setting interface.