Manual

38
Network Camera User Manual
if someone enters into the detection area in 3~5s. The setup steps are as follows.
1. Go to ConfigEventPeople Intrusion. Please refer to the following picture.
2. Enable the people intrusion detection.
3. Set “Alarm Sensitivity” and “Alarm Holding Time”.
4. Set alarm trigger options. The setup steps are the same as motion detection setup. Please
refer to motion detection chapter for details.
5. Set the schedule of the people intrusion detection. The setup steps of the schedule are the
same as schedule recording setup (See Schedule Recording).
※ Configuration requirements of camera and surrounding area
1. The detection area should have stable and adequate light.
2. In order to detect all moving people in the detection area, the height range of the camera
installation should be from 1 meter to 3 meters.
3. To make sure that the camera can capture all indoor objects, the camera lens should be
pointed at the detected direction and the camera had better be installed in the corner of the
room.
4. The range of the captured people image should occupy from 1/5 to 1/2 of the whole picture.
5. The false alarm will be triggered if the indoor scene has cluttered and frequently changing
lights.
6. This function is inapplicable to outdoors.
4.5.7 People Counting
This function is to calculate the number of the people entering or exiting from the detected
area through detecting, tracking and counting the head shapes of the people. The setup steps
are as follows.