Manual

27
Network Camera User Manual
 At any time of day or night, please make sure the image of the camera is clear and with
adequate and even light, avoiding overexposure or too much darkness on both sides.
4.5.1 Object Removal
Alarms will be triggered when the objects removed from or left at the pre-defined area. This
function can be used in such scenarios like object security, debris flow, illegal parking
detection, illegal pasting, illegal doodle, etc.
To set object removal:
Go to ConfigEventObject Removal interface as shown below.
1. Enable object removal detection and then select the detection type.
Enable Left Detection: Alarms will be triggered if there are items left in the pre-defined area.
Enable Item Missing Detection: Alarms will be triggered if there are items missing in the
pre-defined area.
2. Set the alarm holding time and alarm trigger options. The setup steps are the same as
motion detection. Please refer to motion detection chapter for details.
3. Click “Save” button to save the settings.
4. Set the alarm area of the object removal detection. Click the “Area” tab to go to the
interface as shown below.