Quick Start Guide

1
3 Web Interface Configuration
For detailed camera operation on web interface, see Thermal Hybrid Camera_Web Operation
Manual.
Initializing Camera 3.1
Initialize your Camera and set the user password when you are logging in for the first time or
after you have restored your camera to default settings. Initialize the Camera by ConfigTool or
through web. This section takes web for example.
 Ensure your Camera IP address (192.168.1.108 by default) and your PC IP address are in
the same network segment.
 To secure the Camera data, keep admin password well after initialization and modify it
regularly.
Open a browser, enter Camera default IP address in the address bar, and then press Step 1
Enter key.
The Device Initialization interface is displayed. See Figure 3-1.
Initializing camera Figure 3-1
Set the login password for admin account. See Table 3-1. Step 2
Table 3-1 Password setting description
Parameter
Description
Password
Enter your password and enter it again to confirm it.
You are recommended to use strong password. The password must consist
of 8 to 32 non-blank characters and contain at least two types of characters
among upper case, lower case, number, and special character (excluding '
" ; : &).
Confirm
Password
Email Address
Enter an email address to reset password when you forget it.
Click Save and P2P interface is displayed (P2P is reserved for now). Step 3