Operation Manual
Table Of Contents
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Cameras
- 3.2.2 Speed Dome Cameras & Pan Tilt Cameras
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
- Appendix 1 Cybersecurity Recommendations
75
SMTP (Email)
Configure your SMTP server.
For SMTP (Email)’s other parameters to be configured, see Table 4-16.
Table 4-16 SMTP (Email) parameter description
Parameter Description
Anonymity
Enable Anonymity, and senders’ identities will not be displayed in Emails
transmitted to others.
Sender Sender’s email address
Encryption type Select Authentication type from None, SSL and TLS. TLS is set by default.
Attachment Select the check box to support attachment in the email.
Title You can enter no more than 63 characters in Chinese, English, and numbers.
Receiver Receiver’s mail address. Supports 3 addresses at most.
Interval
Time intervals of sending alarm Emails. "0" means there is no interval. Set a time
interval (normally >0s) as you want and when alarm, video detection, or event is
triggered, Emails will not be transmitted all the time but be transmitted in the
time interval you have set. This function is aimed at easing the pressure that is
put on the Email server when there are quite a lot of abnormal events.
Health Mail
The system sends test mail to check if the connection is successfully set. Select
Health Mail to configure Update Period. E-mail testing results will be
transmitted in time intervals you have set.
Test
Test the email sending and receiving function. If the configuration is correct, you
would receive test email. Save email configuration before running rest.
Click Save.