Operation Manual
Table Of Contents
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Cameras
- 3.2.2 Speed Dome Cameras & Pan Tilt Cameras
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
- Appendix 1 Cybersecurity Recommendations
55
The thermal image interface
Configure lens parameters. See Table 4-8.
Table 4-8 Parameter description of lens
Classification Parameter Description
Profile
Profile
Normal, Day and Night can be selected.
Scene (marked by
① in Figure 4-9)
Select the duplicate frame and set the frequently used video
parameter as the user-defined scene. Or, you can select the
default scene and set the display of the thermal image.
Low Dynamic: Thermal images will be displayed based
on the configuration of low dynamic scene.
High Dynamic: Thermal images will be displayed based
on the configuration of high dynamic scene.
Auto: Thermal images will be displayed based on the
configuration of auto scene.