Operation Manual
Table Of Contents
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Cameras
- 3.2.2 Speed Dome Cameras & Pan Tilt Cameras
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
- Appendix 1 Cybersecurity Recommendations
27
The pattern interface
Configure pattern.
1) Select a Pattern No.
2) Click Setup.
Buttons of Start Rec and Stop Rec are displayed.
3) Click Start Rec.
4) Operate the PTZ control panel and adjust you camera’s direction, zoom and focus.
5) Click Stop Rec.
Select a Pattern No. and click Start to start pattern.
Click Stop to stop the pattern.
3.2.2.2.5 Configuring Pan
Pan function makes your camera rotate horizontally at a speed. When you do not have enough
cameras to cooperate for a wide view (a 360° view of a square, for example) or you want to learn the
general situation of an area with only one camera, use the Camera pan function.
Select Setting > PTZ > Function > Pan.
The Pan interface is displayed. See Figure 3-19.
The pan interface
Set a Pan Speed. Click Start to start pan.