Operation Manual
Table Of Contents
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Cameras
- 3.2.2 Speed Dome Cameras & Pan Tilt Cameras
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
- Appendix 1 Cybersecurity Recommendations
163
6 Additional Accessing Methods
Accessing through NVR
Connect this camera to NVR (Network Video Recorder) through Wi-Fi or Ethernet. Then you can set
and manage this camera through the NVR’s web client.
Preparation
Your PC, NVR and your thermal camera are all connected to network.
You have enabled platform accessing function.
You have logged in the NVR’s web client.
Procedure
Select Setting > Camera > Registration.
The Remote Log interface is displayed. See Figure 6-1.
Registration
Click Search.
After the search, the system displays Cameras that have been searched.
Select Cameras whose IP address needs to be modified and click Add.
The following list will display information of tunnel with Cameras. When you log in the
Camera successfully, the connection condition displays .
Web client of NVR recognizes by default that username and password for logging in the
Camera are both "admin." If you have modified your password, add your Camera manually.