Operation Manual
Table Of Contents
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Cameras
- 3.2.2 Speed Dome Cameras & Pan Tilt Cameras
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
- Appendix 1 Cybersecurity Recommendations
159
Restore the Camera to default setting.
Click Default, and all the configurations except IP Address and Account are reset.
Click Factory Default, and all the configurations are reset.
Upgrading Firmware
If a wrong upgrade file has been used, please reboot the Camera, otherwise some functions
might not work properly.
When upgrading, do not cut off power/network, reboot or turn off the Camera.
Select Setting > System > Upgrade.
The Upgrade interface is displayed. See Figure 5-5.
Upgrade
Select an upgrading method you need and upgrade the system.
File Upgrade
1) Click Browse, and upload upgrade file.
The upgrade file should be a .bin file.
2) Click Upgrade to start the process.
Online Upgrade
Only when this thermal camera and your computer are both connected to network, can
online upgrading be implemented.
Detect your system version.
Auto detection: Select Auto-check for updates and click Save. The version is
detected automatically.
Manual detection: Select Manual Check and the system begins to check the
version information.
Version Information
View Camera hardware information, system version and web version.
Versions of different Cameras might vary, and the actual product shall prevail.
Select Setting > Information > Version, and the Version interface is displayed. See Figure 5-6.