Operation Manual
Table Of Contents
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Cameras
- 3.2.2 Speed Dome Cameras & Pan Tilt Cameras
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
- Appendix 1 Cybersecurity Recommendations
149
Certificate creating
2) Configure HTTPS parameters. See Table 4-53.
Table 4-53 Parameters description
Parameter Description
Country Abbreviation of a country. Limited to 2 capital letters.
IP or Domain Name IP address or domain name of your Camera
Validity period Validity period of the certificate.
Province Province where you use this certificate.
Location Location where you use this certificate.
Organization Organization that uses this certificate.
Organization Unit Name of organization unit that uses this certificate.
Email Email of a person or a company who uses this certificate.
3) Click Create.
Requests created will be displayed.
Click Install to start installation. After that, certificate property will be displayed in the
Certificate Installed bar of the HTTPS interface.
Click Delete near the Certificate Installed bar of the HTTPS interface to delete an installed
certificate.
Click Save to store the root certificate.
Install the root certificate.
1) Double-click you have saved.
The dialog box of Certificate is displayed. See Figure 4-105.