Operation Manual
Table Of Contents
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Cameras
- 3.2.2 Speed Dome Cameras & Pan Tilt Cameras
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
- Appendix 1 Cybersecurity Recommendations
129
Isotherm
Select the On check box.
You have to make sure that floor temperature <= median temperature
<= ceiling temperature <= saturation temperature.
Min Limit
Temperature
When gain mode is under low-temperature mode, value ranges
from -40 °C to 150 °C.
When gain mode is under high-temperature mode, value ranges
from -40 °C to 600 °C.
Medium
Temperature
When gain mode is under low-temperature mode, value ranges
from -40 °C to 160 °C.
When gain mode is under low-temperature mode, value ranges
from -40 °C to 600 °C.
Max Limit
Temperature
When gain mode is under low-temperature mode, value ranges
from -40 °C to 160 °C.
When gain mode is under low-temperature mode, value ranges
from -40 °C to 600 °C.
Saturation
Temperature
When gain mode is under low-temperature mode, value ranges
from -40°C to 160
℃.
When gain mode is under low-temperature mode, value ranges
from -40 °C to 600 °C.
Color Code
Select On to enable color code.
A color code will be represented on the right side of surveillance
images.
Click Save.
Effect images are as shown in Figure 4-73, Figure 4-74, and Figure 4-75.
Temperature switch