User Manual

Record & Disk Management
DVR User Manual
51
Click “All” to set all week recording; click “Reverse” to swap the selected and unselected time
in a week; click “Clear All” to clear all the selected area in a week.
7.3.2 Record Schedule Configuration
Click StartSettingsRecordRecord ScheduleSchedule Configuration to go to the
interface as shown below. Set the schedule of sensor record, motion record, timed record and
intelligence record. Click “None” in the drop-down menu to clear the schedule. Click “Apply”
to save the settings.
Go to “Edit Schedules” interface and then click to edit the schedule. The settings of
“Edit Schedule” are similar to that of the “Add Schedule”. Click to delete the schedule.
7.4 Record Mode
7.4.1 Manual Recording
Method One: Click on the tool bar at the bottom of the live view interface to enable
recording of the camera.
Method Two: Go to live view interface and then click the right-click menu “Manually Record
On” in the camera window or click on the tool bar under the camera window to start
recording.
7.4.2 Timing Recording
Timing Recording: the system will record automatically according to the schedule.
Set the timing record schedule of each camera. See 7.3 Schedule Setting for details.
7.4.3 Motion Based Recording
Motion Based Recording: the system will start motion based recording when the motion
object appears in the setup schedule. The setup steps are as follows:
① Set the motion based recording schedule of each camera. See 7.3 Schedule Setting for
details.
② Enable the motion and set the motion area of each camera. See 9.2.1 Motion
Note: Click Start  Settings  Record  Mode Settings and then set the manual record time in the
interface. Click “Apply” to save the settings.