User Manual

Live View Introduction

DVR User Manual

5.3 POS Settings

Some models may not support this function.

① Click StartSettingsBasicPOS Settings to go to the interface.

② Enable POS and click configure under “Connection Settings” to go to the following

interface.

③ Enter the IP address of the POS you want to add.

④ Check “Filter destination”, “Filter POS port” and “Filter destination Port” (If you do not

check them, please skip this step) and enter the destination IP, POS port and destination port

you want to filter.

⑤ Click “Display Position” under “Display Settings” to set the position of the POS

information (Use the default settings of the general settings).