User Manual

Wizard & Main Interface
DVR User Manual
16
required. Network Fault Tolerance and Multiple Address Setting are available.
⑥ Add Camera. Click “Refresh” to refresh the list of online IP cameras which are in the
same local network with DVR and then click to add the searched camera. Click “Add
All” to add all the cameras in the list. Click to delete the added camera. Click “Delete All”
to delete all the added cameras.
Click to edit the searched IP camera as shown on the below left. Enter the new IP
address, subnet mask, gateway and the password of the camera. Click “OK” to save the
settings.
Click to edit the added camera as shown on the above right. Enter the new camera name,
IP address, port, username and the password of the camera. You can check “Sync to IPC” to
modify the IP address of the IPC via different network segments for being in the same network
segment with the DVR. You can click “Test” to test the effectiveness of the input information.
Click “OK” to save the settings. You can change the camera name only if it’s an analog camera