User's Manual

1.4 Transmitter Function
(1) Volume Limiter Function: When turn on the v olume l imiter,i ft he v olume r each
the level which set before, the volume will not increase anymore, at the same
time, the limiter indicator will lights.
We suggest to turn on this function when using the system, it can protect the
user s audition and decrease the distortion.
To gain the best effect, turn on the transmitter, then adjust the output leve lo f
equipment until the volume limiter is flashing.
5
(2) Power:
RF Power 10dBM
RF Power 15dBM
RF Power 20dBM
(3) Gain Control Of Input Level : To the equi pmen t i n lowe r outp ut leve l, operate
in +10dB.
(4) Input Jack:
(5) Input Connector:
Unbalanced Input Connector Balanced Input Connector
2) Volume Limiter Setting: Short press set button
until LIM is flashing, then short press
button to turn on/off the LIM
function. To turn on this function which will display
as , it will limit the volume in a range. To
turn off this function which will display as .
3) Squelch Setting: Short press set button until
SQL is flashing, then short press
button to achieve the squelch setting.
4) Audio Balanced Setting: Short press set button
until EQ is flashing, then short press or
button to achieve the audio balanced setting.
2.6 Headphone
Attention
When progress setting, if none of action will be done for 3 seconds, the
system will exit setting state automatically, and save the current setting.
2.4 Battery Installation for Receiver
Press the battery compartment door
follow the direction instruction to open
Install the batteries follow the battery direction
instruction which shown on the case of receiver
2.5 Receiver Function
(1) Volume Limiter Function:W hen t urn o nt hev olume l imiter, if t he v olume r each
the level which set before, the volume will not increase anymore.
We suggest to turn on this function when use the system , it ca n prote ct th e
user s audition and decrease the distortion.
(3) Squelch Setting: When the signal is lower than the squelch setting, the signal
indicator will light off, and the audio output is in squelch state.
(2) Audio Balanced Setting:
Alt up 6dB
Bourdon up 6dB
Alt & Bourdon up 6dB
Keep the original state
8
KP
1R